Before and during disassembly Case being welded for 100% cleanup in the bores Case top half being indicated in on planer mill Case bottom half being milled to allow stock for line boring and precision gasket surface Case being line bored to re-establish proper dimensional fits Bearing housing being drilled for an RTD Bearing housing hanger faces and seal gland faces being machined to a cleanup Impeller faces have been welded and new wear rings have been installed Sleeve bearing before, during and after lacing Sleeve bearing being finish machined true to the outside diameter register fits to ensure precision alignment Oil galleys being milled Component parts being manufactured to meet or exceed original design standards Impeller after finish machining Newly manufactured shaft of highest quality heat treated and stress relieved shafting material. Components replicated with the highest quality materials Case top half after line boring Element has been balanced and landed in the case Case and case parts Pump has been painted and is ready for delivery